A cost-effective wire management solution.Ancor's Through-Deck Wire Seals allow you to run wire through a surface using a waterproof, strain-relieving seal. The clamping mechanism works like a compression nut or packing gland. As the outer nut is tightened, a seal on the inside contracts around the wire (or tubing) that runs through it. The Wire Seal inserts into the surface and uses an NPT thread nut on the other side (like conduit nuts).Wire Seals provide cable entries into panels and junction boxes for a wide range of wire sizes, including round, flat, duplex and triplex wires. They can also be used for propane enclosures (where a tight connection for solenoid wires is critical), for antenna installations and hydraulic hoses.Key FeaturesMade of nylon 6/6 flame resistant, self extinguishing Buna-N form sealAll seals exceed NEMA 4 x or 6 specsOverlapping clamping spines allow for superior pull-out protection and resistanceStrain relief fittings are resistant to saltwater, acids, alkalis, alcohol, oils and are non-corrosive for use in the marine environmentGood underwater to 300 feet /91.4 m (150 PSIG) provided there is a liquid tight seal between body and housingProvide low cost cable entries into panels and junction boxesSynthetic rubber gasketUL 94 v-0 flammability rating