Fill your way to a perfect finish with Awlgrip Two-Part High-Build Primer.AwlGrip High Build Epoxy Primer is a sandable, two-component epoxy primer that is best used as a surfacer over other AwlGrip primers and fairing Compounds. High Build Epoxy Primer can also be applied directly to properly prepared wood or fiberglass; however, best results are obtained when these surfaces are first sealed with 545 Primer. Base and converter are sold separately. Not for use below the waterline.Key FeaturesEffective for pinholes, small depressions and sanding prepUse where high build and filling is requiredEffective surfacer over other Awlgrip primersUse as a fairing compoundPhysical DataType: Epoxy PolyamideFormulation: High-build primerComponents: 2 (Base and Converter)Mixing Ratio: 1 part base : 1 part converterVOC: White Base (D8002) 347 g/l or 2.9 lb./gallonVOC: Yellow Base (D9002) 338 g/l or 2.8 lb./gallonVOC: Converter (D3002) North America Only 331 g/l or 2.8 lbs./gallonApplication Recommended Application Method: Conventional or airless spray only. Pressure feed equipment required. Not for roll and tip application.Number of coats recommended: 2-3Induction Time after Mixing: 15 MinutesPot Life: @ 77F, 50% RH: 8 hrs.Recommended Wet Film Thickness: 8-10 milsRecommended Dry Film Thickness: 4-5 milsApplication Temperature: minimum 13C (55F) maximum 41C (105F).Primer Needed: 545 PrimerCoverage: 814 Sq. Feet/GallonConverter: AwlGrip (D9001)Drying Time to Full Cure: 12-24 hr.Cleaner: T0006, T0002, or T0031 ReducersMore IinformationFor detailed application instructions, see the